| 1. | The dsp - based drive logic for srm under fault conditions
的开关磁阻电机的带故障运行的驱动逻辑研究 |
| 2. | It also includes thermal protection and current limit , protecting the load and the regulator during fault conditions
具有热保护和电流限制功能,保护工作在不正常条件下的负载元件和芯片。 |
| 3. | Flexible triggering that lets you easily isolate and analyze the complex signals and fault conditions common in mixed analog and
灵活的触发能力,使您能容易地隔离和分析复染的信号,以及在混合模拟和数字电路设计中常见的故障 |
| 4. | Firstly , the dc railway systems throughout the world are surveyed , the various short circuit fault conditions and protection equipment requirements are discussed
文中首先对国内外的地铁系统进行了简单的介绍，特别讨论了各种短路及其保护策略。 |
| 5. | It is , of course , important to choose the resistor so that it neither degrades the noise performance of the system nor allows too much current to pass under fault conditions
因此，限流电阻的选择十分重要，既要限制故障电流，又不能引入太大的噪声。 |
| 6. | A condition wherein a station transmits for a period of time longer than the maximum permissible packet length , usually due to a fault condition
数据站的一种状态，在此状态中，数据站发送数据的时间大于最大允许的包长度。这种状态通常是由故障状态引起的。 |
| 7. | This paper is mainly to discuss the compression algorithm for electric power system fault recording data , which is essential to power system fault condition analyzing
本文重点讨论电力系统故障录波数据的压缩问题。录波数据对于分析电力系统故障十分重要。 |
| 8. | If there are high voltage cables running anywhere near the data cables , the potential for a fault condition exists as a result of insulation failures or inadvertent contact by an installer
如果数据电缆附近有高压电缆经过，在诸如绝缘失效、意外接触设备，则会存在故障电势。 |
| 9. | Pdf low - voltage switchgear and controlgear - part 5 - 3 : control circuit devices and switching elements - requirements for proximity devices with defined behaviour under fault conditions
低压开关设备和控制设备.第5 - 3部分:控制电路器件和切换元件.在故障条件下具有规定功能的接近开关 |
| 10. | Pdf low - voltage switchgear and controlgear - part 5 - 3 : control circuit devices and switching elements - requirements for proximity devices with defined behaviour under fault conditions
低压开关设备和控制设备.第5 - 3部分:控制电路器件和切换元件.在故障条件下具有规定功能的接近开关 |
